Wall PRO™ transparent bumper strip, 30 x 300 cm, colourless, transparent, thick film

NEW

WALL™Pro transparent self-adhesive wall bumper, 0.25 mm thick

The bumper's hard outer surface ensures good resistance to dirt and scratches caused by chair or table legs!

It shows off the colours of the walls very well thanks to its transparent nature. You don't lose the effect of a painted wall, nor do you create the impression of a colour mismatch, as is the case with coloured bumpers!

The corners, which are rounded during the manufacturing process, fit more snugly against the wall surface

Same-day installation - rooms are ready for use straight away - no need to wait for adhesives to dry, etc.

Other features of WALL™Pro:

• quick installation - ready for use straight away
• a surface that is 25% harder and thicker*
• excellent transparency allows the colours of the wall it protects to show through! a new approach to wall protection!
• hypoallergenic for both people and pets
• total thickness: 0.25 mm - without protruding from the wall, it provides excellent protection for the wall's surface
• also works well for pets, protecting walls from scratches and splashes
• Application temperature: -20 to +40°C
• Photo: illustrative image of the WallGLASS wall protector - the standard version does not feature a logo or lettering produced using CNC plotter cutting

*compared to the WallGLASS bumper

Installation instructions and notes:

1. Measure the width and length of the wall you intend to protect
2. Order the original WALL™Pro product from Mathey System in the correct dimensions
3. Dispose of the entire packaging in the waste paper bin (100% paper & cardboard)
4. Clean the surface onto which the WALL™Pro is to be fitted using a dry cloth; remove any unevenness or fine dust (the wall should also be primed before painting)
5. Fit the WALL™Pro to the surface to be protected as shown in the photo, from left to right (or vice versa). You can lightly mark the bottom edge of the skirting board with a pencil to ensure an even distance from the floor. Smooth it out by hand, with a soft cloth or a rubber squeegee. One of our pressure rollers, available as an optional accessory, is also useful.
6. The skirting board can be cut with a standard wallpaper knife; however, as its surface is quite hard, we recommend taking care
7. We're delighted with the benefits of WALL™Pro, but above all with the colour of our wall

! The result depends largely on the quality of the wall's finish, the care taken during preparation (smoothing the surface, priming beforehand, surface cleanliness) and the application of the adhesive itself. Any air pockets that may appear depend on the unevenness of the wall and the type of paint used on it. In most cases, the bumper can be easily removed without leaving any traces of the adhesive layer. More commonly, there may be reduced adhesion or the adhesive layer of the bumper may cause individual patches of paint to peel off (due to inconsistencies in the wall surface itself). It is recommended to carry out a test application on a small, inconspicuous area of the wall. It takes at least 24 hours for the adhesive's bonding particles to migrate into the wall surface; we recommend waiting a few days before subjecting the wall guard to full load.

PLEASE NOTE! Only genuine WALL™Pro wall bumpers from Mathey System guarantee the highest quality!

Genuine WALL™Pro wall bumpers always feature:

• always a special protective border around the actual bumper during transport!!!
• a thickness of 0.25 mm technical laminate, rather than thin film measuring 0.1 mm or 0.15 mm
• rounded edges, which ensure the moulding is fixed to walls much more securely than those with sharp corners
• we manufacture 1.2m, 2.0m, ... bumpers, always to the above standards
• Dedicated technical support at every stage, backed by many years of experience